· FLIGHT CONTROL· COMING SOON
F7 Flight Controller
F7-class flight controller with integrated OSD and Blackbox logging.
· RF / LINK · 915MHz· COMING SOON
915MHz ELRS RX Nano
$59.99
This component is in development. Specifications shown are preliminary - join the waitlist to be notified at launch.
NDAA-compliant 915MHz ExpressLRS nano receiver for long-range links, designed and assembled in the USA.
NDAA COMPLIANT
MADE IN THE USA
- PART NUMBER
- VD-RX900
- PROTOCOL
- ExpressLRS 3.5 (Vult fork)
- FREQUENCY
- 915 MHz (902-928 MHz)
- RADIO
- Semtech SX1276
- MCU
- STM32F103
- FC INTERFACE
- CRSF · 5V / GND / TX / RX pads
- ANTENNA
- U.FL connector
- DIMENSIONS
- 27 × 17 mm
- FIRMWARE
- Vult Dynamics ExpressLRS (GitHub)
- ORIGIN
- Designed & assembled in USA
NDAA-compliant ExpressLRS firmware
Most ExpressLRS hardware runs on Espressif ESP32 and ESP8285 chips, and current ExpressLRS 4.x releases support only those. The Vult RX900 uses an STM32 microcontroller, and ExpressLRS 3.5 is the last release line that supports STM32.
Vult Dynamics maintains an open-source ExpressLRS 3.5 fork that adds the RX900 target. Releases are built from the vult/3.5 branch, signed, and published with SHA-256 hashes so you can verify what you flash. The complete source for shipped firmware is public under GPL-3.0.
View the Vult Dynamics ExpressLRS firmware on GitHub
Works with ExpressLRS 3.x transmitters. ExpressLRS 4.x transmitters will not link with 3.x receivers. An NDAA declaration is available on request.
· ALSO IN ELECTRONICS
· MOTOR CONTROL· COMING SOON
60A 4-in-1 ESC
60A continuous 4-in-1 ESC for high-current FPV and sUAS motor loads.
· RF / LINK · 2.4GHz· COMING SOON
2.4GHz ELRS RX Nano
NDAA-compliant 2.4GHz ExpressLRS nano receiver, designed and assembled in the USA.